Limewash Stone Walls and Chimneys in Federal Way

Typical cost in Federal Way

  • One exterior chimney$750 – $3,000+
  • Entry walls and stair walls, 300–600 sq ft$1,000 – $5,000+

A patchwork of stone colors can be pulled together with limewash on porous stone and mortar, and each stone still shows its shape and shadow. Our stone work around Federal Way covers chimneys, garden walls, old foundations, fieldstone and veneer.

No two stones act quite alike, so every job starts with an absorption test and a sample on your actual wall. Stone jobs in Milton, Algona, Pacific, Des Moines, Fife, Auburn and Edgewood are part of our work too.

Request a free quote

Fieldstone entrance and chimney limewashed in soft bone white

Stone limewash options

Stone house exteriors and veneer

If a stone entry or wainscot looks dated, limewash can soften the mix or tie it to a new siding color. First we find out what is there, because manufactured veneer and natural stone act differently, and that steers the product and coat plan.

Stone chimneys

Rain and wind hit a stone chimney from every side. Before any finish, get the crown, flashing and mortar checked and fixed. After that, limewash brings the stones to one tone without hiding the rough face.

Stone foundations and plinths

Older stone foundations get patched again and again, which leaves a blotchy band around the house. A coat of limewash, the old breathable masonry finish, makes it one color again. We check what moisture is doing below grade before the finish goes on.

Garden walls, piers and outdoor stone

A soft, weathered wash helps an old garden wall sink into the planting, and it works on piers and retaining-wall faces too. Rain hits these walls from every side, so sound caps and good drainage matter as much as the finish.

Interior stone walls

Stone inside can make a room dark, and limewash lightens it, whether it is a feature wall or stone by the kitchen or stairs. Rain is not a worry indoors. If the stone is sealed or very dense, though, it may need a different plan.

Fieldstone garden retaining wall limewashed in soft bone white

How much of the stone should show

Light wash

To keep the wall reading as fieldstone, we stop at one sheer coat. If the product allows, we rinse some of it back while wet. The rusts and grays stay, and only the loudest stones calm down.

Even tone

For a wall that reads as one color from the street, more layers get there, toward bone, chalk or warm gray, and you still see where each stone sits. How many coats depends on the product and the stone, and the sample tells you.

Mortar emphasis

We brush lime into the mortar lines first, then go lightly over the faces. More lime in the joints shows the pattern; less fades it.

Absorption, sealers and moisture

Stone has to drink water for limewash to hold, and granite, very dense stone and sealed stone barely do. To check, drip water on several stones and see whether it soaks in or sits there. That test comes before any decision on a finish.

A shady north wall that is green and damp needs cleaning and time to dry enough to work on. Then we look for the reason it stays wet. Gutters, grading or splashback are common culprits, and fixing them lets the finish breathe.

Request a free limewash quote

List the stone you have in mind, say a chimney, a wainscot or a garden wall, and whether it was ever sealed. Give the property address. We'll get back to you soon with an estimate or any questions we have. Estimates are free and there's no obligation.

Call (253) 785-4892

Call (253) 785-4892