Brick and Stone Fireplace Limewashing in Federal Way

Typical cost in Federal Way

  • One brick or stone surround$700 – $2,500+

A fireplace that is too orange, or stone that is too busy, can be calmed down with limewash, and the texture and mortar lines stay. In Federal Way homes, we limewash brick, stone and plaster fireplaces.

A fireplace is small but fussy, so we clean off the soot, mask the mantel and hearth with care, and help you pick a color that sits right with the rest of the room. We take fireplace jobs in Milton, Algona, Pacific, Des Moines, Fife, Auburn and Edgewood too.

Request a free quote

Living room brick fireplace limewashed in chalky warm white

Fireplace limewash options

Brick fireplaces

Bare brick is the classic case. One or two coats lighten it and tame the red, and the joints still show. A lighter or heavier hand with each coat controls how much of the old color stays.

Stone and rock fireplaces

River rock, stacked stone and fieldstone soak limewash into their faces. The colors line up better, and each stone keeps its outline. Stone that is glassy-smooth or sealed may not take it, and a quick absorption test tells us.

Painted brick fireplaces

A fireplace painted years ago can still be limewashed. After scraping off loose paint, we use a limewash and primer system designed to go over paint. The result reads like limewashed masonry, not flat paint, though with less brick variation showing than on bare brick.

Plaster and drywall surrounds

A newer surround in drywall or plaster takes the primer system your product names, then a limewash coat for a clean, plaster-like look. We do corners and edges by hand, so the whole surround reads as one block.

Full chimney breasts and built-ins

The limewash can run all the way up to the ceiling, or across the built-ins on each side, which turns the fireplace into a feature wall. Doing the whole chimney breast as one piece leaves no hard line where brick meets the wall above.

Dining room enveloped in warm mushroom limewash

Heat, soot and the firebox

Limewash goes only on the parts you see: the surround, the chimney breast and the front of the hearth. It never goes in the firebox. Limewash will not hide soot or grease that bleeds through, so we clean the soot and smoke stains first.

The brick right around the opening gets the most heat and soot. If it dulls, that band can be touched up. With a gas insert or a wood-burner, follow the limewash maker’s guidance near the opening.

Mantels, hearths and color

Your wood mantel needs masking, or it comes off for the job, so the edge stays crisp. The front of a raised hearth can match. The top is different. If you sit on it or set things on it, it needs a protective treatment the manufacturer approves, or leave it natural. For most living rooms, try a warm white, a pale clay or a soft greige. Hold a sample board up next to your floor and furniture before you choose.

Request a free limewash quote

Let us know whether the fireplace is brick, stone or plaster, and whether anyone has painted it, along with the property address. We'll get back to you soon with an estimate or any questions we have. Estimates are free and there's no obligation.

Call (253) 785-4892

Call (253) 785-4892